VW Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1 (Edited)
Hello Everyone!
I'm swaping from auto to manual but I need to know if someone has done it before, I need to know how to connect the speedometer sensor and the backup switch.
Is it necessary to change the ECM??
What about the TCM?
Thanks!!!!
 

·
Registered
Joined
·
368 Posts
its a longgg, and stressful job. Sell the auto and buy a manual.

I had someone ask me to do so, I did, and it cost them $800 in labor, and never mind the parts.
 

·
Registered
Joined
·
316 Posts
you need to swap out the ecm and tcm and have it all encoded or the car will not run and have it coded for the key plus pedals plus shifter and linkage, tranny, mounts clutch, slave cylinder..... a lot of work not with its better to just trade someone
 
1 - 4 of 4 Posts
Top