VW Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Im in the middle of swapping my 1.8L 1996 golf CL engine out for a 2.0L 2001 cabrio engine. I've run into the problem that the wiring harness i got with the engine is for a automatic transmission, but im putting it on a manual. About 90% of the plugs match up to each other, but theres a couple vital ones ( the speedo sensor, back up light sensor, oxygen sensor, etc...). Is there a way to re-wire the harness a little bit to fit the engine and fuse box?

Thanks!
-Rhys
 
1 - 1 of 1 Posts
Top