VW Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
107 Posts
Discussion Starter #1
ok i just need to know all the parts i need to get my baby ready to do the motor i have a port and polished head 1.8 8v 270 cam with a aba bottom end i know i need the block off plate and gasket from TT but would this work 905.200 New Ignition Distributor (2.0L 8v Conv. w/Knock sensor)
will it run right with this since i need a knock sensor
geting a abd short throw shifter
is there any other little things i can do to boost hp i got 600 left for the project

will be having the cross flow head and the 2.0 intake and t-body forsale and what ever other parts i dont use
 

·
Registered
Joined
·
2,513 Posts
I'm not sure about the parts because i've never done it but i would save at least half of the money because once you get started if you run into somthing(which you probably will) then you'll be able to deal with it. If you don't have anymore money then you'll be stuck until you get some more. Ya know what i mean. good luck with the swap. take pics if possible through the whole process.
 

·
Registered
Joined
·
107 Posts
Discussion Starter #3
im ganna be taking pic of the hole project from when the car get rolled in to the shop till the smoke show i do leaving when im done
 
1 - 3 of 3 Posts
Top