VW Forum banner
1 - 1 of 1 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
New member but VW owner for too long to remember, but the '72 Beetle 1600 was the best.

On another note can anyone tell me what the difference in the height is between the flywheel clutch plate face and the pressure plate mounting face on a 6N Polo flywheel is? It's a single piece flywheel.

I had the clutch & pressure plate replaced and the flywheel machined, and now the clutch won't release properly. I'm told the specification is 13.4 mm, I have 0.5 mm. However the machinist still maintains that the flywheel was machined "to spec", but the clutch won't release and the gears grate.

Pic of the problem attached



1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.