VW Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter · #1 ·
My friend said that he has a Volkswagen Polo gasoline ECM ME17.5.26, and used the KTM BENCH 3 IN 1 ECU programmer to successfully read the PLASH and EEPROM data.
Waste container Font Gas Automotive exterior Metal


Make sure the device connections are normal.
1) Connect KTM Bench and the ECU via the professional harness
2) Connect to the computer by USB cable, and
3) Plug the KTM 1.20 32 IN 1 dongle into the computer
Netbook Laptop Touchpad Personal computer Wood

Audio equipment Gas Font Electronic instrument Machine

Wood Audio equipment Electricity Electronic instrument Electrical wiring


Open KTM Bench 3 IN 1 software (KCMflash)
There is a prompt appearing on the screen ‘An updated version was found on the server. Would you like to download build 1.2.4 released on 2021-11-30?’
Click ‘No’ to continue
Select ECU [71] Bosch: MEDC 17 (TC1724/1728/1767/1782/1784/1797) FLASH
Click ‘Identification’
It prompts ‘Would you like to use automatic power control (L-line)’.
Click ‘Yes’ to continue
Computer Personal computer Font Rectangle Technology


Entering reprogramming mode…
Detect the SN, Hardware and ECU successfully
The ECU is TC1724 rev.1.
Computer Personal computer Operating system Rectangle Font


Then click ‘Read’ to read the FLASH data
Confirm to use automatic power control (L-line) again
After approx 2 min, the data was read successfully.
Then save the data.
Computer Personal computer Font Operating system Software


The next step is to select [71] Bosch: MEDC 17 (TC1724/1728/1767/1782/1784/1797) EEPROM
Click ‘read’
Read EEPROM successfully and save the data.
Computer Personal computer Blue Font Rectangle

Computer Personal computer Operating system Font Screenshot


OK! That’s the whole process to read VW BOSCH ME17.5.26 PLASH and EEPROM by KTM Flash KTM Bench KTM OBD1.20 3 in 1 ECU Programmer.
Very simple and nice!
 
1 - 1 of 1 Posts
Top