Did you use a scan tool to clear the code after your repair? If not you may have to.
Timing belt help
I have a VW Jetta 2014 2.0 single cam. My camshaft position sensor was going out so I replaced it and when putting everything back together I accidentally jumped a tooth without knowing. I started it and got code P0016 which is (CMP for bank 1, which detects camshaft rotation, is not corresponding to the crankshaft position sensor (CKP) signal). I tore everything apart again and took the belt off and re timed it. But I am still getting that code. Not sure what to do now. Engine sounds fine just takes a little to start.
Thank you
Thank you
1 - 3 of 3 Posts
Yes after I completed the job I cleared the code and started the car up and the code popped up againDid you use a scan tool to clear the code after your repair? If not you may have to.
1 - 3 of 3 Posts
VW Forum
We’re a forum community dedicated to entirely to all Volkswagen models including the Golf, Jetta, and Passat! Come join the discussion about TDI, Turbos, reviews, maintenance, upgrades, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
