VW Forum banner
1 - 1 of 1 Posts

· Registered
85 Posts
Discussion Starter · #1 ·
Hi Y'all,

GTI 2009 (Dec 2008 labeled as 2009),2.0 TSI engine 6 speed. 198,000 miles
The water pump is belt driven, the small pulley driving the belt is mounted on a shaft coming out of the left side engine. Does anyone know the thread of the nut/axle holding the pulley? Next time I replace the water pump, I want to install a new pulley as well.
Is it regular CW tight/CCW untighten or left thread deal?
Thank you,
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.